Sewer Smugglers' Den Battle Map, Free Download | Text to Tabletop
Sewer Map

Sewer Smugglers' Den

A channel of murky green water runs the width of a brick sewer, with stone walkways on both banks and two footbridges across it. At one end a rusted sluice gate spans the channel where the walkway curves around. Drainage grates let pale light down onto the stones, and behind a breach in the lower wall is a round den with bedrolls, crates and a table lit by a lantern.

Top-down sewer battle map with a green water channel, stone walkways, footbridges and a hidden den

4778 by 3584 pixels, free to use in your games including commercial ones. No account needed to download. Generating your own opens the prompt below in the editor, and new accounts get 3 free maps with no credit card.

Running this map

The footbridges are the only dry crossings, so a fight here is about who controls them. The water is difficult terrain at best and somewhere to hide something at worst. The den is a dead end with one way in, which suits smugglers right up until someone stands in the breach. Opening the sluice gate is a lever the party will want to pull, so decide in advance what it does.

The prompt that made it

This is the exact text the generator was given. Change a detail or two and you get a map that fits your table instead of ours, which is the whole reason the prompt is here rather than hidden.

A long brick sewer tunnel beneath a city, seen from above. A wide channel of murky green water runs the length of the map with narrow stone walkways along both sides, crossed by two arched stone footbridges. A rusted iron sluice gate holds back the water at one end. Through a broken section of the tunnel wall lies a hidden smugglers' den with crates, bedrolls, a table and a lantern. Pale light falls through drainage grates onto the water. Top-down, grid-aligned, battle map style.

Using it in a virtual tabletop

Suggested grid: 20 by 15 squares, 5 feet each

The map is drawn without grid lines on purpose, so you can set your own and have it line up. In Roll20 and Foundry VTT, upload the image, then set the grid to these dimensions and nudge the alignment until the squares sit on the terrain.

The file is a standard image, so it imports into Roll20, Foundry VTT, Owlbear Rodeo and Fantasy Grounds the same way any other map does. It also prints, if your table plays in person. For more maps of this kind, see the sewer map generator.

More free maps

See every map in the gallery, or start with 3 free maps of your own.